Communication base module CM06

Best.-Nr. xxx.9471

With the SCHNEID communication base module CM06, the base module controller can be equipped with up to three bus interfaces:
1. Standard bus for controller networking and system visualization via SCHNEID WinMiocs 70 or SinVIS
2.Bus interface for consumption data acquisition (e.g. meter)
3. Internal controller bus for control networking (SubCOM)

A corresponding bus module can be fitted for each of the three bus interfaces, depending on the application.

The following bus modules are available:
-RS232 bus module
-RS485 bus module
-RS422 bus module
-MBUS master bus module
-MBUS Master 80 bus module
-MBUS slave bus module
-SUBCOM bus module
-USB bus module
-TCP / IP Ethernet bus module

Examples of networking:

Different SCHNEID control units can be linked together on the control side via an internal data bus. Corresponding setpoints and the centrally measured outside temperature are exchanged under the control devices to enable optimized control.

Reading the measurement data from heat meters, electricity meters and other external devices using the M-Bus interface (M-Bus protocol according to CEN TC176 WG4 and IEC1107).
Recorded data using the example of a heat meter: amount of heat, flow rate, flow temperature, return temperature, spread, power, flow rate, etc.

All data from the controller and the heat meter are transferred to the optimization computer in the boiler house via the special SCHNEID-FSS interface.
(see WINMIOCS and FW-MANAGEMENT)

Scope of delivery: SCHNEID communication base module CM06 and connection cable 10-pin (800mm)

Dimensions board (HxWxD) 115x100x44mm

Downloads & Links

DatenblattAnklemmplan